Elektral ThruScan Manual de usuario descargar pdf (Pagina 42)

WARNING: If ‘Remote Control’ warning is displayed on LCD when entered the code,

then the PIN code of the

ThruScan

is set to [8888]. The PIN Code must be changed.

RJ11/12 Connector to observe images from REAL-TIME VISUAL

PROSECUTION UNIT:

Connection is, as follows from left to right;

1.RJ 11/12 Socket

1.EMPTY

2.VIDEO

3.EMPTY

4.EMPTY

5.GND

6.EMPTY

General Characteristics

Video Output : NTSC/PAL TV Out

Image : JPEG 800x600

Video : AVI 5fps 320x240

Image Size : ~80KB (HQ) ~40KB(SQ) (depends on image)

Video Size : ~600KB MPEG, QVGA (320x240), 5fps

Multicapture : 10 images per shot

Capturing : Capturing with motion detect or alarm.

Memory Size : Max. 2GB SD Card supported. Unless SD Card is not on it. it can store in its

memory for a few images. Maximum 1024 folders and for each folder 1024 images can be stored.

Operation

ThruScan Users can make his own keyboard according to the key definition stated and perform the

following

operation.

1 Change mode between view and play back

By default, the DVR is in view mode and show channel 1 when power up. One can press

switch view or playback photo screen

2 Change viewing channel and PIP

2.1 Press

to change view from Ch1 to Ch2

2.2 Press again

and view PIP, Ch2 in Ch1

2.3 Press again

and view PIP, Ch1 in Ch2

2.4 Press again

to cycle from viewing Ch1

3 Capture photo

3.1 Use external trigger to capture: refer to section 4, as below.

3.2 by manually: at View mode, press

to snap an image

3.3 by motion detect: pls refer to the following setup section, once it is in armed mode, the DVR

will capture the image when motion detected.

3.4 Use short cut key (CH +) to arm the system at View mode

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 56 57

Comentarios a estos manuales

Sin comentarios

Elektral ThruScan Manual de usuario Pagina 42

Comentarios a estos manuales