Elektral ThruScan Manual de usuario descargar pdf (Pagina 28)

2. See Counts that are displayed,

3. To reset counts press SEL, and return to MENU,

4. Choose Y(yes) or N(no) by UP&DOWN buttons,

5. Press SEL(√) button to select and fix the setting.

Press UP&DOWN buttons to move to the next sub-MENU option or press RUN(X) button to store

the changes and thus return to the normal operating mode.

4.1.6.2 FOR; ThruScan s9/sX/ sX-WP /s15-i/sX-i

ThruScan has a traffic counter monitoring both incoming and outgoing traffic through WTMD thus

indicates the number of persons passing through the unit in both directions after the last memory

“reset”.

The IN&OUT counter values are displayed on the LCD (screen) and one can compare the difference

between the two counters to find the number of persons still in the building.

The traffic counter memory can be viewed or reset as follows:

1. Press UP&DOWN buttons until the IN<COUNTER>OUT

COUNTER sub-MENU option is displayed,

2. Counter value stored in the memory will be displayed for both

the IN & OUT counters separately,

3. To reset the counters press SEL(√) button to enter the reset

MENU,

4. Select either 00 (do not reset), 01 (reset the IN count), 02

(reset the OUT count) or 03 (reset BOTH COUNTERS) by

UP&DOWN buttons,

5. Press SEL(√) button to select and fix the setting.

Press UP&DOWN buttons to move to the next sub-MENU option or press RUN(X) button to store

the changes and thus return to the normal operating mode.

NOTE: Please ask the alarmed people to walk back through the WTMD so that the in &

out counters wouldn’t count the same person again and again. This way, the number or

the people inside would be accurate.

Continuous operation & detection can be obtained when IR Pass Sensor LEDs are

obstructed.

4.1.7 FACTORY SETTINGS

ThruScan can be returned to factory settings as follows:

1. Press UP&DOWN buttons from the MENU until the

FACTORY SETTING sub-MENU option is displayed.

2. To reset return to factory settings press SEL(√) button to

enter the factory reset MENU.

3. Use UP&DOWN buttons to select Y (YES) or N (NO).

4. Press SEL(√) button to select and fix the setting.

IN < COUNTER > OUT

00000 00000

IN < COUNTER > OUT

00000 00000

ACTIVE = 00

FACTORY SETTINGS

Y<==>N

FACTORY SETTINGS

Y<==>N

ACTIVE = N

COUNTER

00002

Y<==>N

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 56 57

Comentarios a estos manuales

Sin comentarios

Elektral ThruScan Manual de usuario Pagina 28

Comentarios a estos manuales