Elektral ThruScan Manual de usuario descargar pdf (Pagina 22)

3.6 RELAY CONTACT OUTPUTS (RJ11/12)

Relay contacts (for phone connector) are present on ThruScan (on the side panel or

on the control unit). This feature provides to control and use of peripheral equipment

such as CCTV, Camera, Turnstiles, Gates, etc. .

These contacts; ((RJ11/12) can be used for 24 VDC/2 Amps.)

1- NO (Normally Open)

2- NO (Normally Open)

3- Common

4- Common

5- NC (Normally Closed)

6- NC (Normally Closed)

*** Contact numbers of the socket are coded as they appear on the picture/WTMD from left to

right.

CAUTION! Relay Output does not function with “Real-Time Video Prosecution Unit”

equipped Walk-Through Metal Detectors.

3.7 SYNCHORNIZATION AND REMOTE CONTROL OUTPUTS (RJ11/12)

This socket (for phone connector)*** is for two or more WTMDs to be used in tandem

and/or for remote control by using the direct cable or a modem via phone line. See

Section 6.13 and Section 7.1

1- Transmitter1

2- Transmitter2

5- Ground/Earth (Norm)

6- RS 232

*** Contact numbers of the socket are coded as they appear on the WTMD from left to right.

4. PROGRAMMING & SET UP

Programming and set up is performed as follows after the password is entered by

touch pads:

NOTE: Default Password for all ThruScan WTMDs is “ 0000”.

NOTE: The password should only be known and entered by the authorized personal.

Only one person should hold responsibility for procedures requiring the password. The

operator should only be in charge of operating

ThruScan

and do the security control.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 56 57

Sin comentarios

Elektral ThruScan Manual de usuario Pagina 22